Feed Direction For Router Tables On a router table, bits spin counterclockwise. For routing the outside edges of a work- piece then, you’ll feed the wood from the right side of the table to the left side. Doing this forces the bit to push the wood back against you.Click to see full answer. Similarly, it is asked, what direction do you go with a router?When looking straight down at the top of a router, the bit rotates in a clockwise direction. That means you should move the router from left to right, but—and this is important—that’s only true when the router is positioned in the middle between you and the workpiece.One may also ask, what is the difference between a fixed base router and a plunge router? With a fixed base router, the position of the router bit is constant. A plunge base router is designed so that you can preset the cut depth and then lower (“plunge”) the bit into the cut with the router’s base flat on the surface of the material. In respect to this, what is feed direction? For hand-held routing applications, the feed direction refers to the direction in which the router bit is fed into the material. In a hand-held router, the router bit spins in a clockwise direction, so the feed direction will usually be from left to right.How does a plunge router work?Plunge Routers Go Where No Other Router Can. A lock/release lever allows free up-and-down movement of the router housing or locks it in place at a given depth. The depth of cut can be preset, allowing you to position the router over the work and plunge the bit to an exact depth.