Skip planing is a term that indicates just a light pass was taken and the entire material isn’t cleaned up. It is generally done so you can see the figure in the wood better than in the rough stage. Any light pass would be considered skip planed.Click to see full answer. Also asked, what does planed wood mean?Planed wood is sawn timber which has been planed down until it’s smooth, and is meant for use where it can be seen. Planed wood, on the other hand, offers a wealth of possibilities as it has been machined down until it’s smooth, with the quality visible from every side.Beside above, should I buy a jointer or planer first? The jointer is used to flatten one face and square up one edge and the planer is then used to make the second face flat and parallel to the first. In my opinion, you should purchase the planer first. You’ll be able to accomplish more with it on its own than you can with a jointer. Secondly, should I reclaim wood plane? Absolutely no metal can go through the planer/jointer. You may not want to plane those boards. * Use a hand sander to sand all sides of the wood. You can get away with just one pass The sander will find any last metal you missed.Does a planer make wood flat?A jointer creates a flat surface on wood, and yes, it can be used to correct bow and warp on one side of a board at a time. “A planer is a thicknesser. It takes a thick board and makes it thinner. To use a planer, the board should already have one flat side.