Rollout switches trip because flames are burning back where they are not supposed to be. Possible causes include a stopped up vent, a stopped up heat exchanger, low gas pressure, or a cracked heat exchanger. A cracked heat exchanger can also lead to tripped rollout switches.Click to see full answer. Similarly, it is asked, what does a rollout switch look like?Roll out switches are generally located near your furnace’s burner box. They are round, with a switch sticking out of the top. Two strips of metal of equal length (about an inch long each) are attached to either side of the switch. The metal strips have a hole at the end furthest from the switch.Additionally, what is a rollout switch? The rollout switches are placed as a safety device around the burner area to sense the hot flame or hot exhaust thus shutting down the furnace so you do not get a fire or get carbon monoxide poisioning. The push button manual set rollout switch is located in the middle. Herein, why does my limit switch keep tripping? Like any other part in your HVAC system, the high limit switch can wear out over time. One of the most common issues that happens when a high limit switch goes bad is that it fails to signal the blower fan to turn off. High limit switches can also weaken over time so that they begin tripping at a lower temperature.How do you reset a rollout switch?Press and release the raised red button at the center of the flame roll-out switch to reset the furnace. You can press the reset button up to three times before troubleshooting the furnace’s internal components or calling for repair service; allow 30 minutes between each reset.