Turn the adjustment screw clockwise to raise the headlight and counterclockwise to lower the headlight until the center of the headlight beam sits at the bottom of the garage door where the door meets the ground.Click to see full answer. Moreover, how do you adjust the headlights on a Nissan Altima?Use the Torx bit screwdriver to loosen or tighten the adjustment screw on the rear of each headlight to pull the light into the proper alignment. Turn the screw clockwise to raise the headlight beam and counterclockwise to lower the beam.Beside above, how do you clean the headlights on a 2014 Nissan Altima? Place about 5 tablespoons of baking soda into a bowl and add enough warm water to form a paste. Clean your headlights using soap and water before applying the paste. Apply the baking soda paste to your headlights using the corner of your sponge. Polish your headlights with a clean cloth using a small circular motion. Moreover, where are the headlight adjustment screws? Most adjustment screws are located on the top and side of the light housing. They should be clearly marked. If you cannot locate the screws, check your owner’s manual. It should be noted that some manufacturers have located the adjustment screws in the engine compartment behind the headlight housing.How do you adjust the headlights on a Nissan Sentra? How to Adjust the Headlights in a Nissan Sentra Put weight in the driver’s seat to compensate for the lack of a driver. Position the car on a level surface 25 feet from a wall that is at least as wide as the car. Get the measurement from the center of each headlight, or the aim dot, to the ground. Determine the location for your adjustment screws.