To prime the water pump and get water into it: Raise the top lever on your Nespresso pod coffee machine vertically. Press the Lungo or Espresso button once. Push the top lever back a bit further, it will go about half an inch beyond the vertical. Click to see full answer. Also asked, how do I reprogram my Nespresso machine? Reset to factory settings With machine being turned off, press and hold down the Lungo button for 5 seconds. LEDS will blink fast 3 times to confirm machine has been reset to factory settings. LEDs will then continue to blink normally, as heating up, until ready. One may also ask, how do you reset a Nespresso citiz? Nespresso Citiz Turn the machine off. Press and hold down the Lungo button for 5 seconds. The LEDs will blink fast 3 times to indicate it has been reset to Factory settings. The LEDs will continue to blink normally as the machine heats up until ready to use. Steady lights: machine is ready. Also, how do you reset the water level on a Nespresso machine? Turn off the machine’s power button. Then hold Lungo button for 5 seconds while the machine is turned off. The buttons will flash rapidly three times, and your Nespresso Inissia® has now been restored to factory settings.How do I prime my Nespresso machine? To prime the water pump and get water into it: Raise the top lever on your Nespresso pod coffee machine vertically. Press the Lungo or Espresso button once. Push the top lever back a bit further, it will go about half an inch beyond the vertical.